| |
|
|
| Educational Software Planet / welcome |
|
|
    |
|
 |
 |
Our Pick |
 |
|
 |
is a molecular visualization software adapted from the program RasMol. I had been looking for a replacement for the formerly free WebLab Viewer program, and this is an outstanding candidate. |
 |
|
|
|
|
|
|
|
|
|
|
This program, for analysis of turbine steam condensers, can either calculate the performance of a known condenser, or can calculate the design requirements of a new condenser for a known steam load. The steam and condensate properties are built in. Also a complete range of tube properties are built in. The cleanliness of a given condenser can be etermined quickly using a trial and error method. |
|
|
|
Cooling Tower Analysis is a powerful, user friendly, program for the analysis of induced, mechanical-draft, counterflow cooling towers. The program can be used for the analysis of existing towers or for the preparation of specifications for new towerss. |
|
|
|
This program calculates the performance of a steam, shell-and-tube heat exchanger of known construction using rigorous formulations. Steam and water properties are built in. The type of fouling can be specified. The shell-side fluid is always steam. The tube side fluid can be any non-condensing fluid. |
|
|
|
This program calculates the amount of steam that can be generated by a fired or unfired waste heat boiler (Heat Recovery Steam Generator). The steam and condensate properties are built in. The program first calculates a design mode and then an "off-performance mode" for changed conditions |
|
|
|
This program calculates the heat loss and surface temperature of an insulated pipe of specified diameter and internal temperature. It then calculates the present worth cost, $/foot, to own and operate each insulated system. This allows the user to select the optimum insulation thickness for each pipe based either on the cost of the insulation and heat loss or on the maximum acceptable surface temperature. Four types of insulation are supported. Pipe sizes through 36" are included. Three layers of insulation are supported ranging in thickness fro |
|
|
|
Heat Exchanger Performance is a powerful, user friendly, program for the analysis of two types of Heat Exchangers: Shell & Multi-Tube Exchangers, and Double Pipe Exchangers. In either case, the tubes are of the bare-tube type. The program will analyze the performance of a known heat exchanger: Given the flows and inlet temperatures of the Tube-side fluid and the Shell-side fluid, the program will predict the exit temperatures of both fluids and the total heat exchanged |
|
|
|
Tri MAXTM is a powerful software resource for the practicing engineer, chemist, or student. It is your best source of data. Through the use of menus: data and functionality are put at the finger tips of the power user. Tri MAXTM provides data such as periodic table, steam tables, heat capacities, critical values, viscosities, diffusion coefficients, thermal conductivities. Math functions are also provided, such as linear regression, quadratic equation, curve fitting, and a calculator that goes far beyond the standard calculators available for MicrosoftTM Pla |
|
|
|
1 2 3 4 5
|
